Encore ENDSL-A2PLUS4R2 Manual do Utilizador descarregar pdf (Página 22)

Configure IP Address Manually:

Step 5: Select Use the following IP address and Use the following DNS server

addresses.

IP address: Fill in IP address 192.168.1.x (x is a number between 2 to 254).

Subnet mask: Default value is 255.255.255.0.

Default gateway: Default value is 192.168.1.1.

Preferred DNS server: Fill in preferred DNS server IP address.

Alternate DNS server: Fill in alternate DNS server IP address.

You can use ping command under DOS prompt to check if you have setup TCP/IP

protocol correctly and if your computer has successfully connected to this router.

1) Type ping 192.168.1.1 under DOS prompt and the following messages will appear:

Pinging 192.168.1.1 with 32 bytes of data:

Reply from 192.168.1.1: bytes=32 times<2ms TTL=64

Reply from 192.168.1.1: bytes=32 times<1ms TTL=64

Reply from 192.168.1.1: bytes=32 times<10ms TTL=64

2) If the communication link between your computer and router is not setup correctly,

after you type ping 192.168.1.1 under DOS prompt following messages will appear:

Pinging 192.168.1.1 with 32 bytes of data:

Request timed out.

Cable issue or something wrong might cause this failure in configuration procedure.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 84 85

Sem comentários

Encore ENDSL-A2PLUS4R2 Manual do Utilizador Página 22