Encore SIM EDITOR SOFTWARE Guia do Utilizador descarregar pdf (Página 408)

100

101

17-24

VCD+ (vpd) File Generation

Simulator Run-Time Options

Specific command line options are used to generate VCD+. These

options are used to set the RAM buffer size, provide the VCD+ default

file name, specify the VCD+ file size, ignore file calls, check licenses,

and control what information is stored. This section describes the

following commands:

• +vpdbufsize to control RAM Buffer Size

• +vpdfile to set the output file name

• +vpdfilesize to control maximum file size

• +vpdignore to ignore $vcdplus calls in code

• +vpddrivers to store driver information

• +vpdports to store port information

• +vpdnocompress to bypass data compression

+vpdbufsize to control RAM Buffer Size

To gain efficiency, VCD+ uses an internal buffer to store value

changes before saving them on disk. The +vpdbufsize command

modifies the size of that internal buffer. The minimum size allowed is

what is required to share two value changes per signal.

Syntax:

+vpdbufsize+nn

Where nn is buffer size in megabytes (default is the size required to

store 15 value changes for each signal but not less than 2 megabytes).

1 2 ... 403 404 405 406 407 408 409 410 411 412 413 ... 448 449

Comentários a estes Manuais

Sem comentários

Encore SIM EDITOR SOFTWARE Guia do Utilizador Página 408

Comentários a estes Manuais

Manuais e produtos relacionados com Software Encore SIM EDITOR SOFTWARE